Serving the Houston area  ·  (832) 209-7659  ·  Open Mon-Sun 7am-7pm
📞 (832) 209-7659 Free Quote

Metal Roofing in Missouri City, TX (77459) · Local Professionals

Houston Metal Roofing · Fast response in Missouri City and the Houston area · Free estimate 24h

✅ Licensed Contractor 🛡️ Licensed & Insured 💸 Free Quote 24h 🕐 Mon-Sun 7am-7pm
+196Verified Reviews
10Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Licensed & Insured

Missouri City is a mix of brick ranches from the 1970s and 80s, newer two-story homes out toward Sienna, and a growing number of large-lot builds near Riverstone. The flat Gulf Coast prairie and expansive clay soil here mean your roof takes a beating from summer heat, spring hail, and tropical downpours. We know this city block by block, from the older streets off Highway 6 to the newer subdivisions along the Fort Bend Tollway.

Homeowners in Missouri City (77459) call Houston Metal Roofing because we show up when we say we will, we know how to handle the hail and wind that roll through here, and we install roofing that actually sheds heat and water instead of just looking good on day one. When a storm knocks a limb onto your roof or you spot a leak near the chimney, we are the crew that answers the phone.

Metal Roofing in Missouri City (77459)

Missouri City sits on flat ground with heavy clay soil that shifts with every wet and dry cycle, so roof alignment and flashing details matter more than they do on solid rock. Older neighborhoods like Texas Parkway and the streets around Missouri City Middle School have mature pecan and oak trees that drop limbs and shade roofs just enough to grow algae and mildew. Newer areas near Sienna and Riverstone have tighter lot lines and HOA rules that affect panel profiles and colors. We deal with both every week.

Our team has installed and repaired metal roofs across Fort Bend and Harris County for years. We know how to work around the low slopes on some of the older ranches, how to ventilate a roof over a vaulted ceiling, and how to keep a standing seam roof from oil-canning when the sun hits it. We pull permits through the city and coordinate with HOA architectural review committees so you do not have to chase paperwork.

Our services in Missouri City

How a Job Works in Missouri City

Step 1: You call (832) 209-7659 or send a message, and we schedule a free on-site assessment. We look at your roof, your attic, your gutters, and how water is draining off your lot. We take photos and give you a written estimate with options, not pressure.

Step 2: Once you approve, we pull the required permits (the City of Missouri City website is a good place to start understanding local requirements) and order materials. On installation day, our crew protects your landscaping, sets up a staging area, and gets to work. If your HOA needs a color approval, we handle that before we order panels so there are no delays.

Step 3: When the job is done, we walk the property with you, magnet-sweep for nails, and haul away every scrap. We do not leave until you have looked at the roof, the gutters, and the cleanup and signed off. We also give you a maintenance checklist so you know what to watch for during storm season.

Pricing in Missouri City depends on the size and pitch of your roof, how many layers are already there, and how easy it is to get materials to the site. As a ballpark, corrugated panel roofing starts around $5.50 per square foot, metal roof installation starts around $8 per square foot, and standing seam starts around $10 per square foot. A basic metal roof repair or leak repair starts around $450, and screw replacement or re-fastening starts around $750. Gutters for metal roofs start around $9 per linear foot. If your roof is storm damaged, we offer a free inspection and work with your insurance documentation, but we never promise coverage or suggest a deductible can be waived. Call (832) 209-7659 for a free estimate on your specific roof.

My 1980s brick ranch near Quail Valley has a low-pitch roof and old shingles. Can you install metal over them?
Yes, a metal roof over shingles (retrofit) is often possible if your existing roof has only one layer and the decking is sound. We check the structure and flashing details first, because low slopes need extra attention to water shedding. We will tell you honestly if a full tear-off makes more sense for your home.
A storm just blew limbs onto my roof in Missouri City. How fast can you get out for an emergency repair?
Call (832) 209-7659 and we will schedule the soonest available inspection, usually within a day or two for active leaks or storm damage. We tarp or patch the immediate problem to stop water intrusion, then give you a written scope for permanent repairs. We do not promise a specific arrival time until we have your address and details.
What does a typical metal roof replacement cost for a 2,000 square foot house in Missouri City?
For a 2,000 square foot home, a metal roof replacement often falls in the range of $18,000 to $30,000 depending on the panel type, roof complexity, and whether we tear off the old roof. Standing seam costs more than corrugated or ribbed panels. We give you a line-item estimate after we see the roof, so you know exactly what you are paying for.
Do I need a permit from the City of Missouri City for a new metal roof?
Yes, roofing permits are commonly required for a full replacement or re-roof in Missouri City, and the rules vary by project scope. We pull the permit for you and schedule the required inspections. You can also check the City of Missouri City website for general information, but we handle the paperwork so you do not have to navigate it alone.
My HOA in Sienna requires approval for roof color. Can you help with that, and what about property lines?
We coordinate with HOA architectural review committees regularly and can provide product specs and color samples for your application. For property lines, your roof and gutters must stay within your lot, and we follow local setback rules. If a neighbor has concerns, we keep the conversation factual and work with the city if needed.
Are you fully insured for work at my Missouri City property?
Yes, we carry general liability insurance and workers' compensation coverage. That protects you if anything goes wrong on your property, and it means our crew is covered while they are on your roof.
What maintenance should I do on my metal roof in Missouri City to prevent leaks during hurricane season?
Check fasteners and seals every spring, clear gutters and downspouts of debris from pecan and oak trees, and look for loose panels or lifted flashing after any windstorm. Algae streaks are common in shaded areas, so a gentle wash helps. We offer inspections and re-fastening services starting around $750 if you would rather have a professional take a look.
Why choose us?

Trusted professionals in Houston

🏅

Licensed contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Licensed & Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sun 7am-7pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Metal Roofing Services in Houston

All your work handled by qualified professionals in Houston

Metal Roof Installation

Complete metal roof systems engineered for your local climate and built to outlast three shingle roofs.

Included in your service

  • Deck inspection and repair before any panel goes on
  • High-temp synthetic underlayment and correct ridge and soffit ventilation
  • Manufacturer-certified panel, trim, and flashing details for the full warranty
  • Free on-site assessment and written estimate within 24h
Learn more→

Standing Seam Metal Roofing

Concealed-fastener standing seam: no exposed screws to loosen, leak, or need re-torquing.

Included in your service

  • Panels roll-formed to the exact length of your roof, no end laps
  • Mechanically seamed or snap-lock profiles with concealed clips
  • Floating clip system that lets panels expand and contract freely
  • Kynar 500 / PVDF finish in the full architectural color range
Learn more→

Metal Roof Replacement

Full tear-off of an end-of-life shingle, cedar, or metal roof, replaced with a complete new system.

Included in your service

  • Tear-off and haul-away of the old roofing, dumpster included
  • Decking inspected board by board, rot and soft spots replaced
  • New underlayment, drip edge, valleys, and penetration flashing throughout
  • Documentation of the finished system for your insurer or future buyer
Learn more→

Metal Roof Over Shingles (Retrofit)

Retrofit metal installed over sound existing shingles: no tear-off, less waste, lower cost.

Included in your service

  • Honest deck and shingle assessment first, recover only when it is the right call
  • Furring strips or slip sheet as the panel profile and local code require
  • Existing vents, pipe boots, and flashings reworked to the new roof plane
  • Straight guidance on when tear-off is the better long-term choice
Learn more→

Metal Roof Repair

Targeted repair of damaged, loose, or storm-hit metal roofing before it reaches your ceiling.

Included in your service

  • Bent, dented, or punctured panels replaced and color-matched
  • Seams, laps, and penetrations resealed with compatible butyl and sealant
  • Failed pipe boots, closures, and ridge cap fasteners renewed
  • Written findings with photos of what we found and what we fixed
Learn more→

Metal Roof Leak Repair

Priority leak response: we trace the leak to its real source instead of caulking the symptom.

Included in your service

  • Water testing and interior tracing to find the true entry point
  • Backed-out fasteners, separated seams, and flashing gaps corrected at the cause
  • Emergency tarping available same day after a storm
  • Attic and insulation moisture check so hidden damage does not sit and spread
Learn more→

Screw Replacement & Re-Fastening

The top cause of leaks on 15 to 30 year old screw-down roofs, fixed for a fraction of replacement.

Included in your service

  • Every fastener replaced with oversized screws and new EPDM sealing washers
  • Dried-out washers and stripped holes addressed panel by panel
  • Ridge, eave, and sidewall closures renewed at the same time
  • Restores a watertight roof without replacing sound panels
Learn more→

Corrugated & Ribbed Panel Roofing

Corrugated, tuff-rib, and 5V panel roofing: the budget-friendly workhorse for homes and outbuildings.

Included in your service

  • Galvalume and painted steel panels cut to length on site
  • Correct screw pattern and torque so washers seat without over-driving
  • Foam and metal closures at ridge, eave, and rake to keep weather and pests out
  • Full color range for homes, cabins, barns, and workshops
Learn more→

Metal Shingle Roofing

The look of architectural shingle, slate, or shake with the lifespan and wind rating of steel.

Included in your service

  • Interlocking stamped steel or aluminum shingle panels
  • Walkable finished surface, easier to service than a standing seam field
  • Lightweight enough for retrofit over an existing roof structure
  • Profiles and colors that suit historic and HOA-governed neighborhoods
Learn more→

Stone-Coated Steel Roofing

Steel strength under a textured stone finish, with strong hail and wind performance.

Included in your service

  • Acrylic-bonded stone granule surface over structural steel
  • Battened or direct-to-deck installation depending on the profile
  • Class A fire rating and high impact resistance ratings
  • Tile, shake, and shingle textures for suburban and coastal homes alike
Learn more→

Copper & Specialty Metal Roofing

Copper, zinc, and aluminum for porches, bay windows, dormers, and full architectural roofs.

Included in your service

  • In-house fabrication of pans, valleys, and custom curved details
  • Soldered seams and joints where the detail calls for it
  • Isolation of dissimilar metals to prevent galvanic corrosion
  • A living patina that develops over decades of service
Learn more→

Metal Roof Coating & Painting

Restoration for faded, chalking, or surface-rusted metal, adding 10 to 15 years without replacement.

Included in your service

  • Wash, degrease, and mechanical prep of the entire panel surface
  • Rust treatment and primer on affected areas before topcoat
  • High-performance elastomeric or silicone coating system applied to spec
  • Honest assessment first: we say so when the roof is past coating
Learn more→

Flashing, Chimney & Skylight Repair

Flashing is the number one leak point on any metal roof, and it is what we fabricate best.

Included in your service

  • Custom bent step, counter, and apron flashing made in-house
  • Chimney crickets to shed water on the uphill side
  • Skylight curbs and head flashing rebuilt to the panel profile
  • Valley and wall transition details closed with matching trim
Learn more→

Snow Guards & Ice Protection

Snow retention that stops rooftop avalanches onto decks, gutters, walkways, and entryways.

Included in your service

  • Pad-style guards or continuous rail systems matched to your panel
  • Layout calculated from roof pitch, panel length, and local snow load
  • Clamp-on mounting on standing seam, no panel penetrations
  • Ice dam and eave detailing for higher-elevation homes
Learn more→

Storm & Wind Damage Repair

Wind, hail, and fallen-limb repair with thorough documentation and a straight repair-or-replace answer.

Included in your service

  • Free post-storm inspection with dated photo documentation
  • Emergency tarping and temporary weatherproofing when needed
  • A written report you can use when documenting your insurance claim
  • Honest assessment of repair versus replacement, with no pressure either way
Learn more→

Metal Roof Inspection

A written, no-obligation assessment of fastener condition, seams, flashing, and remaining service life.

Included in your service

  • Fastener, washer, and seam condition checked across the field
  • Flashing, penetrations, and closures inspected point by point
  • Coating wear, chalking, and corrosion graded panel by panel
  • Written report with photos and a straight answer on years remaining
Learn more→

Gutters for Metal Roofs

Gutters sized and hung correctly for metal roofing, where standard hangers and spacing do not work.

Included in your service

  • Seamless aluminum or half-round systems formed on site
  • Hanger placement and spacing matched to the panel profile
  • Oversized capacity and downspouts sized for heavy regional rainfall
  • Bracket spacing tightened for high-wind zones so storms do not tear the gutter off
Learn more→

Commercial & Agricultural Metal Roofing

Barns, workshops, churches, and light commercial metal roofing across the county.

Included in your service

  • Long-run panels for wide spans and low-slope structures
  • Purlin and framing attachment detailed for the building type
  • Insulation, vapor barrier, and condensation control options
  • Repairs and re-fastening for aging agricultural metal buildings
Learn more→
Verified client reviews

196+ Verified Client Reviews in Houston

⭐⭐⭐⭐⭐ 4.9/5 · 196 verified Google reviews

Free Quote

Get Your Free Quote

Metal Roofing in Houston · Response within 24h · No commitment · ☎ (832) 209-7659

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Licensed & Insured 📍 On-site visits included in Houston ✅ No hidden fees 🕐 Available Mon-Sun 7am-7pm